Gigabit Ethernet (and an early Fast Ethernet variant, 100BASE-T4) use all four pairs and also requires the other two pairs (1 and 4) also to be swapped. Such a cable will work for 10BASE-T or 100BASE-TX. A crossover cable may also be used to connect two hubs or two switches on their upstream ports.īecause the only difference between the T568A and T568B pin/pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see Jack crossover wiring). Since 10BASE-T and 100BASE-TX use pairs 2 and 3, these two pairs must be swapped in the cable. One terminal may be connected directly to another without the use of a switch or hub, but in that case the crossover must be done in the cabling. A standard straight through cable is used for this purpose where each pin of the connector on one end is connected to the corresponding pin on the other connector. When a terminal device is connected to a switch or hub, this crossover is done internally in the switch or hub. The 10BASE-T standard was devised to be used with already existing twisted pair cable installations with straight-through connections, and so it required a simple scheme for plugging devices together. This requires that the transmit pair of each device be connected to the receive pair of the device on the other end. The 10BASE-T and 100BASE-TX Ethernet standards use one wire pair for transmission in each direction. Many devices today support Auto MDI-X capability, wherein a patch cable can be used in place of a crossover cable, or vice versa, and the receive and transmit signals are reconfigured automatically to yield the expected result. By contrast, patch cables or straight through cables are used to connect devices of different types, such as a computer to a router (or network switch or hub). two computers (via network interface controller) or two switches to each other. It is most often used to connect two devices of the same type: e.g. An Ethernet crossover cable is a type of Ethernet cable used to connect computing devices together directly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |